RGB - PLCC6/5050 12V LED Strip - Adhesive Backing - 5m Roll / Reel

In stock
Super bright RGB plcc6 5050 12v (volts) led strip with adhesive backing! Use them for Xbox 360 mods, PS3 mods, Wii mods and many other electronics. Great for car mods too! Low power, ultra bright!

This is an Entire Reel / Roll = 5 Meters (16.4 Feet).

Hooking up LEDs could never be easier! You don't have to worry about resistors or anything of that nature. Simply add your 12v power and ground to the strips and watch them GLOW!! Watch your project illuminate better than ever with these 12v RGB (Red, Green, Blue) LED strips!

The led strips can be cut to desired length (cut between contact points). Power and Ground solder points, to add power to the strips, are labeled clearly.

This is one of the most versatile and easy to use led products out there to make any project look amazing. The strips are very bright and have high quality 3M adhesive backing (peel and stick). The strips are very flexible, so they can go around corners and in tight areas.

With an RGB controller you can make the entire strip into nearly an unlimited amount of colors, make them fade, flash, etc... They are an extremely versatile strip that won't disappoint you. All of this can be done at the touch of a button (RGB controller sold separately from the LED Strips).

Some of the colors that are possible: pink, purple, white, warm white, blue, yellow, orange, green, red and everything in between.

Recommended Accessories: 5A 12v Power Supply and an RGB Controller

Common Uses of these LED Strips

  • Console Lighting
    • Microsoft Xbox 360
    • Microsoft Xbox 360 Slim
    • Microsoft Xbox One
    • Sony Playstation 3 (PS3)
    • Sony Playstation 4
    • Nintnedo Wii
  • Cabinet Lighting
  • Kitchen Lighting
  • Under Cupboard Lighting
  • Accent Lighting
  • Car Lighting
  • Marine/Boat Lighting
  • Halloween Lighting
  • Hutch Lighting
  • Anything else you can imagine

More Information
Size12v Strip - 5050 / PLCC6 - 10mm Width
ColorRed/Green/Blue (RGB)
LED Count300 LEDs / 5m (meters) - 3 LEDs / 5cm (one section)
Operating Voltage12v DC
Drive ModeConstant Voltage (12v DC)
Mount Style3M Adhesive Backing Tape
Current72 Watts / 5m (meters) - 60mA / 5cm Section (doesn't consume max during operation)
DimensionsWidth: 10mm Height: About 2.5mm Length: 5cm - 5m (meters)
Operating Temp. (Temperature)Recommended Range = -20C - 50C (-4F - 122F)
Waterproof / ResistanceNo
Viewing Angle120 Degrees
Luminosity/Brightness270 - 300 Lumens / Meter
WavelengthRGB (varied)
Resistor Built InYes
Additional Resistors RequiredNo
Write Your Own Review
You're reviewing:RGB - PLCC6/5050 12V LED Strip - Adhesive Backing - 5m Roll / Reel
Your Rating
Lighthouse LEDs, LLC Payment Methods
© 2023 Lighthouse LEDs, LLC Store. All Rights Reserved.