12v 3528 LED Strips With Adhesive - By the Section (5cm)

$0.75
In stock
SKU
12VLEDSTRIPBYSECTION
  • Buy 10 for $0.50 each and save 33%
  • Buy 20 for $0.40 each and save 47%
  • Buy 50 for $0.30 each and save 60%
Super bright white plcc2 3528 12v (volts) led strip with adhesive backing and waterproof! Use them for Xbox 360 mods, PS3 mods, Wii mods and many other electronics. Great for car mods too!

LED Strip by the Section. 1 quantity = 1 x 5cm Section (2.54")

When you purchase more than one section within a given color and type you will get one continuous strip. That strip can be cut every 5cm or 2.54 inches between the contact points.

Hooking up LEDs could never be easier! You don't have to worry about resistors or anything of that nature. Simply add your 12v power and ground to the strips and watch them GLOW!! Watch your project illuminate better than ever with these 12v LED strips!

The led strips can be cut every 5 centimeters (cut between contact points). Power and Ground solder points, to add power to the strips, are labeled clearly.

This is one of the most versatile and easy to use led products out there to make any project look amazing. The strips are very bright and have high quality 3M adhesive backing (peel and stick). The strips are very flexible, so they can go around corners and in tight areas.


Common Uses of these LED Strips

  • Console Lighting
    • Microsoft Xbox 360
    • Microsoft Xbox 360 Slim
    • Microsoft Xbox One
    • Sony Playstation 3 (PS3)
    • Sony Playstation 4
    • Nintnedo Wii
  • Cabinet Lighting
  • Kitchen Lighting
  • Under Cupboard Lighting
  • Accent Lighting
  • Car Lighting
  • Marine/Boat Lighting
  • Halloween Lighting
  • Anything else you can imagine



Note: The strips are water resistant, not waterproof. The coating on the outside of the strips that makes them water resistant does not take kindly to freezing temperatures if they are bent. It is recommend to make perfectly straight "runs" with the strip if you anticipate it will be subjected to cooler weather.

More Information
Size12v Strip - 3528 / PLCC2 - 8mm Width
ColorN/A
LED Count300 LEDs / 5m (meters) - 3 LEDs / 5cm (one section)
Operating Voltage12v DC
Drive ModeConstant Voltage (12v DC)
FlexibilityFlexible
Mount Style3M Adhesive Backing Tape
Current24 Watts / 5m (meters) - 20mA / 5cm Section = 2A Whole Reel
DimensionsWidth: 8mm Height: About 2.5mm Length: 5cm - 5m (meters)
Operating Temp. (Temperature)Recommended Range = -20C - 50C (-4F - 122F)
Waterproof / ResistanceDepends on Choice
Viewing Angle120 Degrees
Luminosity/Brightness200 - 300 Lumens / Meter (Depends on Color)
WavelengthColor Dependent
Resistor Built InYes
Additional Resistors RequiredNo
Write Your Own Review
You're reviewing:12v 3528 LED Strips With Adhesive - By the Section (5cm)
Your Rating
You may upload your own images that portray this specific product being used. We do ask that you do not watermark them in any way and such images will be declined. Images that are accepted may be used as product images, in tutorials, or other related articles. By uploading an image, you accept to these terms. These images may not directly represent the product on this page. The items shown may have been modified/changed and the images are shown for demonstration, ideas, and creativity only. Colors depicted in the photos may also be "skewed" from difficult nature of capturing true light colors with a camera.
Lighthouse LEDs, LLC Payment Methods
© 2021 Lighthouse LEDs, LLC Store. All Rights Reserved.