Red - PLCC6/5050 12V LED Strip - Adhesive Backing - Waterproof - 5cm Section
Super bright red plcc6 5050 12v (volts) led strip with adhesive backing and waterproof! Use them for Xbox 360 mods, PS3 mods, Wii mods and many other electronics. Great for car mods too!
Each quantity represents 5 cm (about 2 inches) of LED tape (3 leds per section). Quantity discounts can be viewed near the add to cart button and are automatically applied.
The led strips can be cut every 5 centimeters, so if you order more than 1 they will be in one continuous strip unless more than 100 is ordered (5 meters or roughly 5 yards). Power and Ground solder points, to add power to the strips, are labeled clearly.
This is one of the most versatile and easy to use led products out there to make any project look amazing. The strips are very bright and have high quality 3M adhesive backing (peel and stick). The strips are very flexible, so they can go around corners and in tight areas.
Common Uses of these LED Strips
- Console Lighting
- Microsoft Xbox 360
- Microsoft Xbox 360 Slim
- Sony Playstation 3 (PS3)
- Nintnedo Wii
- Cabinet Lighting
- Kitchen Lighting
- Under Cupboard Lighting
- Accent Lighting
- Car Lighting
- Marine/Boat Lighting
- Anything else you can imagine
|Size||12v Strip - 5050 / PLCC6 / 1210 - 10mm Width|
|LED Count||300 LEDs / 5m (meters) - 3 LEDs / 5cm (one section)|
|Operating Voltage||12v DC|
|Drive Mode||Constant Voltage (12v DC)|
|Mount Style||3M Adhesive Backing Tape|
|Current||72 Watts / 5m (meters) - 60mA / 5cm Section|
|Dimensions||Width: 10mm Height: About 3mm Length: 5cm - 5m (meters)|
|Operating Temp. (Temperature)||Recommended Range = -20C - 50C (-4F - 122F)|
|Waterproof / Resistance||Waterproof / Resistant - IP65|
|Viewing Angle||120 Degrees|
|Luminosity/Brightness||850 - 900 Lumens / Meter|
|Resistor Built In||Yes|
|Additional Resistors Required||No|
Write Your Own Review