xbox 360 controller mod

  1. Xbox 360 Controller ROL/Dome Mod with Automatic On/Off Switch

    This tutorial is meant to work if you use it just as it says. There are a lot of calculations involving the resistor values for the transistor. You must use four 3mm leds or a total of 80mA in leds if you would like it to work as we have intended it to in this tutorial. If you stray from...
  2. Xbox 360 Ring of Light Controller Mod / LED Swap

    What you will need:   20-30 Watt Soldering Iron (we, at niktronix use 30 Watt) Rosin Core 60/40 .40 Solder Soldering Stand (highly recommended) Tweezers (can't do it without these) Four 0603 SMDs in your choice of color Xbox 360 Controller Look at our Polarity Guide if you don't know the which side is + and - for your 0603 SMD...
  3. How to Open the Xbox 360 Controller

    What you will need for this tutorial: Security Torx T8 Driver Simply remove the screws as shown on the following spots. Don't forget the 'hidden' screw underneath the bar code behind the battery cartridge (it is shown in the picture). This one gets most people the first time. Once this is done place or hold the controller with the top facing...
  4. Xbox 360 Wired and Wireless Controller AXBY SMD LED Light Mod

    The first thing you need to do is take apart your controller so you have just the board. Please check the link below to do this if you do not already know how:How to Open The Xbox 360 ControllerOnce this is done you will need the following items:4 x 0603 SMDsWireSolderSoldering IronHot Glue GunResistors (make sure you have the correct...

4 Item(s)

Lighthouse LEDs, LLC Payment Methods
© 2021 Lighthouse LEDs, LLC Store. All Rights Reserved.